GTR
Motors:
- Only JK “Falcon” motors are allowed.
- Motor may be ground at the rear to provide rear axle clearance.
- No other modifications are allowed.
Chassis:
-
Only mass-produced 4” "Flexi" style chassis allowed.
-
Pin tubes may be added and chassis may be braced.
-
Only bushings allowed - no ball bearings.
-
Pan movement may be increased or restricted.
-
Front axle towers may be trimmed.
-
Front axle is not required.
-
Front wheels must be at least 1/2inch (.500") diameter and may be attached to the body.
-
No lightweight pans allowed.
-
Lead weight may be added.
-
Rear tire width may not exceed .810".
-
Vertical Motor Mount may be trimmed and/or removed.
-
No other modifications allowed.
Clearance:
· The chassis and spur gear must not touch the track at tech inspection and must not drag on the track during qualifying runs or any time during the race. Initial clearance must be at least 0.032 inches.
Bodies:
· Body must be cut along the manufacture’s cut line.
· Only the below listed JK bodies are allowed:
o C5R Corvette, JKP-71131A
o C6 Corvette, JKP-7126A
o Ferrari Marenello, JKP-7113A
o Jaguar GTS, JKP-71111A
o Aston Martin, JKP-7124A
o Cadillac CTS, 7123A
o Other bodies as approved by the members prior to the race.
