1/32 GTP
Motor:
- Only JK “Hawk 7” motor is allowed.
- No modifications are allowed.
- Motor may be soldered into chassis.
Chassis:
- Only the Cheetah 11 1/32 chassis (JK-HC1132)
- Pin tubes may be added and chassis may be braced.
- Only bushings allowed - no ball bearings.
- Pan movement may be increased or restricted.
- Front axle is optional.
- Front axle support may be trimmed for body clearance or removed altogether.
- Front wheels must be at least ½” (0.500") diameter and may be attached to the body.
- Lead weight may be added.
- Rear tire width must not exceed .635 inches in width.
- Maximum Car width is 2.65 inches excluding body pins.
- Vertical Motor Mount may be trimmed and/or removed.
- No other modifications allowed.
Clearance:
- Car must have 0.032 inches clearance as measured at the rear axle including gear.
Bodies:
- Any 1/32 GTP bodies from JK, Parma, Red Fox and Outisight.
- Body must be cut along the manufactures cut line (if provided).
